Conventional Hydraulic Power Units

Conventional Hydraulic Power Units

These conventional single-circuit skid-mounted hydraulic pump units are suitable for the operation of all Hydra-Slide skidding systems, turntables, and alignment shoes, as well as most double-acting jacking applications.

They are suitable in applications that do not require synchronized flow rates. With non-synchronous power units, there is a single oil supply circuit. It may be split into more than one outlet port, but since they are connected, they will act as one. The pressure will remain constant in all lines but the flow rates may differ.

If the load is heavier at one end, cylinders with lower loads will advance more quickly. When jacking, it is necessary to jack “end to end” to ensure load balance. When skidding, it is necessary to ensure that both cylinders advance at nearly the same rate. Our non-synchronous power units are equipped with flow control or needle valves to help equalize the flow rates to each cylinder.

Include 10,000 psi (700 bar) two-speed pump
Available in gasoline or electric drive
Master control valve
Pressure outlet and return inlet manifolds
4-outlet pressure manifolds have needle valves and a counterbalance valve
2-outlet pressure manifolds have flow control valves
Pressure gauges on each manifold
System pressure relief valve
Pressure and return outlet ports have CR400 female quick couplers

Model 5-1G (Gasoline)

Unit comes complete with:

  • 5.5 HP Honda 4-cycle gasoline powered engine
  • two-stage pump (480/100 cu.in/min)
  • 10 gallon reservoir
  • 1 manually operated Enerpac control valves
  • 1 adjustable relief valve, 2 pressure gauges
  • 2 Tee fittings
  • 2 pressure port outlets with flow control valves and CR400 quick couplers
  • 2 return ports with CR400 quick couplers.

Model 3-1E (Electric)

Unit comes complete with:

  • 3 HP Electric Motor (208-240 Volt, 3Ph, 50-60Hz)
  • two-stage pump (850/120 cu.in/min)
  • 10-gallon reservoir
  • 1 manually operated Enerpac control valve
  • 1 adjustable relief valve
  • 2 pressure gauges
  • 2 pressure port outlets with flow control valves and CR400 quick couplers
  • 2 return ports with CR400 quick couplers

Model 10-1G (Gasoline)

Unit comes complete with:

  • 10 HP Briggs & Stratton electric start 4-cycle gasoline powered engine
  • two-stage pump (900/200 cu.in/min)
  • 10 gallon reservoir
  • 1 manually operated Enerpac control valve
  • 1 adjustable relief valve, 2 pressure gauges
  • 1 counterbalance valve
  • manifold with 4 pressure port outlets with needle valves and CR400 quick couplers
  • 4 return ports with CR400 quick couplers

Model 7-1E (Electric)

Unit comes complete with:

  • 7.5 HP Electric Motor (208-240 Volt, 3Ph, 50-60Hz)
  • two-stage pump (900/200 cu.in/min)
  • 10-gallon reservoir
  • 1 manually operated Enerpac control valve
  • 1 adjustable relief valve
  • 1 pressure gauge
  • 1 counterbalance valve
  • 4 pressure port outlets with needle valves and CR400 quick couplers
  • 4 return ports with CR400 quick couplers

Hydraulic Hoses

Our hoses are fully tested and rated as a jacking hose with maximum working pressure of 10,000 psi. They come complete with CH604 quick couplers on each end. 50 ft length (15m) is standard, with custom lengths available